¶ Camera
¶ mipi camera
¶ Hardware connection
- The MIPI CSI of the R1 development board is adapted to the YY3568 Camera.
- Use 30 pin 0.5mm spaced, same direction FPC flexible cable to connect YY3568 Camera.
- The blue part of the flexible cable is facing upwards. The YY3568 Camera is connected to the flexible cable as shown in the figure below.
- When connecting the FPC flexible cable to the r1 development board, pay attention to the CSI interface of the camera.
¶ Software configuration
5. Click Terminal--Enter the following command
sh /rockchip-test/camera/camera_rkaiq_test.sh
The effect is as shown below
¶ usb camera
- Plug the usb camera into the usb3.0 interface of the r1 development board.
- Click Terminal--Enter the following command
sh /rockchip-test/camera/camera_rkaiq_test.sh
The effect is as shown below